ower supply :5-24V ( default ) ,if you need 5V voltage .please leave a message

Output : NPN OR PNP

cable length : standard length 2m

Model: 400, 600, 360P / R incremental rotary encoder, AB two phase. The up-and-down counting pulse signal can be completed by the generation of the 90° phase between A phase and B phase.

Performance:

Working voltage: DC5-24V, maximum mechanical speed 5000 rpm, electrical frequency 20K / sec, integrated speed 2000 rev / min.

Dimensions: Encoder body size: φ38mm; shaft φ6×13mm; off-axis platform: height 5mm, φ20mm; fixing hole: M3 screw, 3 mounting holes on 30 circle, and 3 mounting holes on 28 circles ; side outlets.

Connection mode: green =A phase, white =B phase, red =Vcc positive power, black =V0 ground, please according to the above method wiring.Another metal screen mesh layer anti-interference.

Matters needing attention:

A and B phase transmission line must not directly connect VCC, otherwise it will burn the output of three stage tube.

Output:AB phase output rectangular orthogonal pulse, the circuit output is NPN open collector output type, the output type and with internal pull-up resistor on the MCU or PLC directly connected, such as MITSUBISHI PLC (51 MCU or PLC input mode should switch to 0V ftion), note: if the encoder is not connected to the device to the oscilloscope oscillographic (time, open collector output resistance in the absence of the output voltage is not) to wave at AB phase output plus two pull ups;

Use:Used to measure the speed, angle, acceleration, and length of an object.

Range of use:Applicable to all kinds of displacement measurement of intelligent control, automatic fixed length automatic leather cutting machine, steel cutting fixed length controller, civilian measured height and body scale, University game robots.

Characteristic:The utility model has the advantages of small size, light weight, convenient installation and high cost performance.