Full Protocol OBD2 Jumper Used to Connect ECU Units Device for ECU Programing Via PPS/ FGTECH/ KESS/ BYSHUT/ DISPROG
Full Protocol OBD2 Jumper for ECU Programing
Full protocol OBD2 jumper is used to connect ECU for ECU programming via OBD2 way such for MPPS, FGTECH, KESSV2, BYSHUT, DISPROG, etc.
Why Do You Need a Full Protocol OBD2 Jumper?
1. Supports DC power supply
2. Support safety protection banana head super programming dedicated connection port power supply.
3. Independent GND4, GND5 [meet the needs of special ECU programming].
4. With boot GND4 clip, compatible for programming equipment such as MPPS, FGTECH, KESSV2.
5. With GND4 GND5 short-circuit switch (some ECUs need to be switched to short-circuit mode when programming).
Note: The switch of GND4-5 is normally pressed to make it light. When some ECUs need to be independently connected to GND4 and GND5, release the switch.
6. With ignition analog switch (equipped with 1 large and 2 small dedicated ignition cables).
7. Support standard obd2 full protocol connection (double K line, double CAN line), 3 large and 2 small power plugs, 4 large GND, 4 small GND.
8. Equipped with CAN protocol communication resistance.
Material: Plastic
colour: As shown
Package Contents:
1 x Full Protocol OBD2 Jumper