KQ2U/KB2U04-02S Y type external thread tee pneumatic PU air pipe joint plastic quick insert quick joint vortex cold air Q304 Pipe Fittings Accessori
kq2u-kb2u04-02s-y-type-external-thread-tee-pneumatic-pu-air-pipe-joint-plastic-quick-insert-quick-joint-vortex-cold-air-q304-pipe-fittings-accessori
ข้อมูลสินค้า
ราคา
414.79 240.00 บาท
แบรนด์
OEM
ร้านค้า














Follow the store for extra discounts





Note: KB and KQ belong to the same model, only some companies call it different!!



Maximum pressure: 1Mpa



Minimum pressure: 0.1mpa



Suitable hose material: nylon, soft nylon, polyurethane



Ambient and fluid temperature: -5~60 ℃



Look at the gauge







Select the model you need according to the size specified in the above drawing. You can directly click: KB2U04-M5  KB2U04-M6   KB2U04-01S  KB2U04-02S  KB2U06-M5  KB2U06-M6  KB2U06-01S  KB2U06-02S  KB2U06-03S  KB2U08-01S   KB2US08-02S  KB2U08-03S  KB2U08-04S  KB2U10-01S  KB2U10-02S  KB2U10-04S  KB2U12-02S  KB2U12-03S  KB2U12-04S  KB2U12-06S  KB2U16-03S  KB2U16-04S  KB2U16-06S Which one will jump directly to the corresponding link 



 



 



X2



 



Notes:



1. The selection of joint shall be proved or verified to avoid danger.



2. The outer diameter of the soft trachea should be within the range of +-0.15mm, while the outer diameter of the hard trachea should be within the range of +-0.1mm.



3. The insertion end of the trachea shall be sheared and smoothed along the vertical end surface with a special appliance. When it is pulled out, the stuck part shall be cut off.



4. When the trachea is inserted, it should be confirmed that the trachea is inserted in place, and the exposed part of the trachea should be kept parallel to the connector line as far as possible, so as to avoid air leakage caused by bending of the trachea.



5. When tightening the thread connection, a wrench must be used to pull the metal hexagon of the joint. The rotation of the plastic shell is only limited to the adjustment of the output direction of the air pipe.



6, inch thread connection is coated with sealant, but in case of excessive negative thread can be sealed with raw tape, especially the used old joint.



7. The end face of metric thread shall be closed with flat washer or rubber ring.




 



 




 



 




 



 




 



 




 



 




 



 








คำที่เกี่ยวข้อง
pipe jointplastic jointhot air quickplastic tube for jointair pipecold airjointcold air intakethread insertquick charger type c

สินค้าใกล้เคียง