The design of the lens hood is basically designed to prevent unwanted external light from penetrating the lens, extending and blocking at the end of the lens;The dedicated lens hood is designed to match the focal length of its design lens.Suitable for most UV lenses.
Stop rays entering the lens in the extreme corner and reflecting in the lens.In the backlight, side light or flash photography, non-imaging light can be prevented from entering and smog can be avoided.
In the smooth and sidelight photography, it is possible to avoid scattered light from entering the lens.In light photography or night photography, ambient light can be prevented from entering the lens.
It can prevent accidental damage to the lens, and it can also prevent the finger from touching the lens surface by mistake. It can also shield the lens from wind, sand and snow.
Hoods are widely used in backlight photography and, in general, glare can be avoided. However, if the light source is close, glare may still occur. At this point, the hood can be blocked by hand on the side where the light source is located. Glare is eliminated, it is necessary to observe clearly from the viewfinder
Item color: black
Material: High-quality rubber
lens hood Size: 72mm/62mm/67mm/77mm
Product weight: 25g{including packaging}
Package Included:
1 * lens hood
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.