Product Information:

Product Name: Car Interior Decorative Light

Voltage: 12V

Color: RGB

Operating Temperature: 20 ° C to 60 ° C

Waterproof: Yes

Mobile Application Control: fit iOS and Android

Functions: 16 million colors (RGB), 29 lighting modes, Less heat radiation, low power consumption, long service life, 360 degree for adjusting, Bluetooth connection phone APP control

Application: Great for car decoration, parts, camping, bar decoration and so on

Light Mode:

1.Sound Active Effects:The LED under car glow system is equipped with sound sensors that lets the LED lights synchronized with music beat. The LED music light strip follows the beat and adjusts flashing to fit the strength of the sound.

2.Music Decoration: The Kit designed to be simple, yet also provides elegance inside the car when driving at night or enjoying music. And because it has sound sensor, the under car glow system synchronize with music beat.

3.Fall Asleep Mode: The Led light will have fall asleep mode. This mode can automatically change dark brightness to provide a good sleep atmosphere.

4.Brightness Color Temperature Adjustment:The LED is equipped with brightness color temperature adjustment mode. When you feel the light is dark,you can use this mode to change brightness.

Installation Steps:

1. Determine the location in the car where you want to install it.

2. Measure the length of the part to be installed, then cut the same length on the optic fiber and the transparent tube.

3. Pass the cut optic fiber through the transparent tube from step 2.

4. Install the transparent tube with fiber optic in the location where it needs to be installed (use the included tool to pry open the slit in the location to be installed).

5. Link the light strips to the transparent tube installed in step 4.

6. Other locations in the car that need to be installed just repeat the above steps.

7. Place the wires and LED lights in the appropriate location (can be hidden in the center console, under the footrest or other places).

8. Connect the cig lighter to the controller, power up.If the optical fiber and transparent tube are installed at sharp corners, please minimize the abrasion of the optical fiber.

If the length of a section of optical fiber used during installation is long, it is recommended to install a light strip (RGB LED beads) at each end of the fiber to increase the brightness.

APP Connection Steps:

1. Scan the QR code on the controller to download the APP.

2. Turn on your cell phone bluetooth.

3. Power up the light strip.

4. Open the APP and connect the light (connect in this APP).

Note:

Please allow 1-5cm deviation due to manual measurement.Due to light and screen difference, the item's color may be slightly different from the pictures.