【Mobula7 1S ELRS】HappyModel Mobula7 1S ELRS Micro FPV Whoop Drone 75mm ExpressLRS 2.4GHz FC AIO X12 V2.1
mobula7-1s-elrs-happymodel-mobula7-1s-elrs-micro-fpv-whoop-drone-75mm-expresslrs-2-4ghz-fc-aio-x12-v2-1
ข้อมูลสินค้า
ราคา
3,950.00 บาท
รีวิว
1 ครั้ง
แบรนด์
No Brand
ร้านค้า

We’re glad to launched our new Mobula7 drone , this time the 75mm whoop based on 1s power. Thanks to the new AIO flight controller and the new third-generation RS0802 brushless motor, the new Mobula7 1s Will be the best choice in the whoop season.

The world first 5-IN-1 AIO flight controller with ExpressLRS 2.0 , OPENVTX(up to 400mw), 12A Brushless Blheli_S ESC and Betaflight OSD coming out recently. This is amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight controller.

The new RS0802 motors comes with a new unibell design, use 1.5mm shaft and include PCB bottom plate, high efficiency and much more reliable.

New onboard OpenVTX , max power up to 400mw, provide RCE and PIT mode, it was very useful for race event.

Features:

X12 5-IN-1 AIO flight controller built-in 2.4G ELRS V2.0 and Openvtx

VTX Power up to 400mw

ELRS V2.0 Support

NEW RS0802 KV20000 motors

Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera

Smooth and powerful

Compatible for 1S Lipo/LIHV

Recommend 1S 450mah/550mah/650mah battery(Not include)

Specifications:

Brand Name: Happymodel

Item Name: Mobula7 1S 75mm Micro FPV whoop drone

Wheelbase: 75mm

Size: 99mm*99mm*40mm

Weight: 24g

Spare parts specifications:

Motor:

Mode: RS0802 KV20000

Configu-ration:9N12P

Stator Diamter:8mm

Stator Length:2mm

Shaft Diameter:Φ1.5mm

Motor Dimension(Dia.*Len):Φ10.5mm*13.5mm

Weight(g):2.0g

No.of Cells(Lipo):1S only

Propellers:

Weight:0.24g

Material:PC

Pitch:1 inch

Props Dia:40mm

Center Thickness:5mm

Center Hole Dia:1.5mm

Flight controller:

X12 ELRS V2.0 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280

MCU:STM32F411CEU6 (100MHZ, 512K FLASH)

Sensor: ICM20689(SPI connection)

Mount hole size: 25.5mm*25.5mm

Power supply: 1S battery input (DC 2.9V-4.35V)

Built-in 12A(each) Blheli_S 4in1 ESC

Built-in Betaflight OSD(SPI Control)

Built-in 5.8G OpenVTX 0mw~400mw

Built-in ExpressLRS 2.4G

Built-in voltage detection

Built-in current sensor

Onboard 4in1 ESC:

Power supply: 1S LiPo/LiPo HV

Current: 12A continuous peak 15A (3 seconds)

Support BLHeliSuite programmable

Factory firmware: Z_H_30_REV16_7.HEX

Default protocol: DSHOT300

Support Bluejay firmware

When use Blujay firmware with 48khz, should set startup power to 1100/1200

Onboard SPI ExpressLRS 2.4GHz Receiver:

Packet Rate option: 50Hz/150Hz/250Hz/500Hz

ExpressLRS Firmware version: V2.0

RF Frequency: 2.4GHz

Antenna: SMD antenna

Telemetry output Power: <12dBm

Receiver protocol: SPI ExpressLRS

Compatible with ExpressLRS V2.0 TX Module

Couldn’t flash separately ExpressLRS firmware

Onboard 5.8g OPENVTX :

Firmware version: OPENVTX

Smart audio v2.1

PIT Mode support

RCE Mode support

Channels:48ch

Transmitting Power: 0/RCE/25mw/100mw/400mw

Power supply: DC 5V

สินค้าใกล้เคียง

Copyright © 2023 KadSan.com - เวลาโหลด 0.016 วินาที.