PG245 PG-245 Refillable Ink Cartridge For Canon 245 246 PG 245 CL-246 Pixma iP2820 MX492 MG2924 MX492 MG2520 Printer

Kindly Notice :

Different Area use different ink cartridge model although printer model is same!

Please check your original ink cartridge model number before place order.

and this cartridge with ink

BKPackage Content:

1PCS x  Black REFILL Ink Cartridge

CPackage Content:

1PCS x Tri-color REFILL Ink Cartridge

1SETPackage Content:

1PCS x  Tri-color Ink Cartridge

1PCS x   Black Ink Cartridge

1SETwith ink Package Content:

1PCS x  Tri-color Ink Cartridge

1PCS x   Black Ink Cartridge

4pcs x 30ml dye ink

1set x Absorbent clip

Note: Logistics is other logistics, not your choice

Printer Model:

Pixma IP2820 MX492 MG2924 MX492 MG2520 Printer

Pixma MG2924 MG2920 MG2922 MG2420 MG2400 MG2580 Printer

Q&A

1）the printer shows "NO ENOUGH INK" or "EMPTY" or theIndicator light “BLINKING”

It’s not quality Problem.

This is VERY COMMON with remanufactured cartridges as the ink gauge cannot be reset.

To resume printing, click "Ok" or "Continue" through any prompts.

If your printer has an LCD screen, press "Ok" on it.

2）Error Message “Not Recognized” Cartridge Damaged"... ...

For this situation, usually has two reasons:

2. ink cartridge chip dirty

Solution:

1. remove the problem cartridge from its cradle inside the printer, and double check the copper strip is intact.
2, take a PENCIL ERASER, and firmly eraser over the contacts,
3  Re-install the cartridge into the printer.

If the problem persists, reset your printer by:

1. Turn off computer AND printer with cartridges installed

2. Unplug printer and leave everything off for 2 minutes

3. Restart printer AND computer and attempt to print again.

3） POOR PRINT QUALITY

Example in picture:

please run a cleaning cycle. Once one cycle completes, your printer will print a test page.

If you are NOT satisfied,

please follow these to make sure the printhead nozzles are not clogged with dry ink:

1. Take a lint free towel () and fold it in half.

2. Remove the cartridge from the printer, locate the printhead (on the bottom side of the cartridge),  hold the cartridge with printhead facing downward and press it to the coffee filter for 3 seconds.

3. Lift the cartridge up - you should see an ink blot on the coffee filter.