Premium quality high conductivity silicone thermal glue.

With a thermal conductivity greater than 0.975 w/m-k this strong silicone based non-electrically conductive glue is perfect for use with our range of premium high-power LEDs where the use of higher thermal conductive compounds is not possible/required. This glue is also suitable for other high temperature applications such as CPU cooling and transistor cooling.

This product is fully CE and RoHS compliant and provides a safe and affordable solution to safely dissipate heat away from your components directly to a heat sink. The utilisation of a good quality high thermal conductive compound is essential to keep components cool, prolong their life and allow them to perform at optimal levels. Each tube contains 5 grams of thermal compound that will suffice for the installation of around 10 x 1W / 3W LEDs with PCB directly onto a heat sink.

Colour : White

Thermal conductivity:> 0.975W / mK

Hardness: 78±5

Specific Gravity : > 2.3 g/cm²

Tensile Strength : 2.1 Mpa

Shear Strength : 1.8 Mpa

Melting capacity: 0 (200 ℃ / 24Hours)

evaporation: 0.001% (200 ℃ / 24Hours )

Thermal impedance:
Table dry time: 5 ~ 15min (25 ℃)
Bond strength: 1.8Mpa
Insulation coefficient> 5.1

Dissipation factor <0.005

Working temperature: -60 ~ 250 ℃

Capacity: 5 g

Scope: For non-fixed clip small heat sink thermal paste

Performance:

The thermal conductivity and good insulation of one-component RTV silicone, the product has good conductivity, wide temperature range ( -60 ~ 200 ℃), short-term resistant to 300 ℃ temperature. In addition, a surface curing time is short, strong adhesion, long shelf life, non-toxic, solvent-free, it can be safely used in electronics, electrical, instrumentation, the LED flexible adhesive, heat sink and other industries, cooling, insulation and packaging.

Instructions:

1 , the use of this product directly to the extrusion, rub the surface of the adherend, cover immediately after use to prepare for the trial again;

2 , the surface of fixed speed and air humidity and temperature; the higher the temperature, the faster the curing speed, whereas the slower;

3 , the proposed smear thickness: 0.1-0.5mm , the thinner the better.

4 , prior to use the adhesive surface with a clean solvent (such as alcohol), should not wash with detergent before painting until the surface is clean.